Heat Pump Repair in Clackamas, OR
Clackamas's older Sunnyside-corridor homes were built for natural gas with single-stage furnaces — most are ready for heat pump conversions but need an electrical-panel audit first. Many homes here still run on the original 1970s-era 100-amp service.
Trusted by Portland Homeowners
Heat Pump Repair · Clackamas
Same-day heat pump diagnosis: refrigerant, defrost, reversing valve, inverter board.
Clackamas is an unincorporated census area along the I-205 corridor between Happy Valley and the Damascus-area border. 1960s–1980s ranches and split-levels along Sunnyside Road dominate the housing stock, alongside newer subdivisions ringing the Clackamas Town Center area.
Clackamas's older Sunnyside-corridor homes were built for natural gas with single-stage furnaces — most are ready for heat pump conversions but need an electrical-panel audit first. Many homes here still run on the original 1970s-era 100-amp service.
We're 12 minutes from our Oregon City shop, so our trucks roll through Clackamas most days of the week.
Local proof
What we actually look for on heat pump repair calls in Clackamas.
This is the local context a generic service page usually misses: the streets we work near, the housing stock we see, and the constraints that change the quote before a crew starts work.
Nearby neighborhoods
ZIP 97015
Common home type
Clackamas is an unincorporated census area along the I-205 corridor between Happy Valley and the Damascus-area border. 1960s–1980s ranches and split-levels along Sunnyside Road dominate the housing stock, alongside newer subdivisions ringing the Clackamas Town Center area.
Job constraint we check
We test heating, cooling, defrost, reversing valve behavior, and inverter faults before leaving. Older 100-amp electrical panels in 1960s–1980s Sunnyside-corridor homes that need upgrading before a heat pump install can land code-correct.
Permit and paperwork
Most repairs in Clackamas do not need a permit. If the call turns into replacement, panel work, or a larger code item, we flag that before quoting the next step.
Review/case note
On Clackamas heat pump calls, a system can cool normally and still fail in defrost or heat mode. We run both modes before calling it fixed.
Why Clackamas chooses us
Local crew, real credentials, transparent pricing.
Manufacturer-trained
Trane Comfort Specialist + Mitsubishi Diamond Contractor + Energy Trust of Oregon Trade Ally — all three manufacturer-recognized credentials.
Licensed + bonded
Oregon CCB# 247087, BBB-accredited, fully bonded and insured. Permits pulled on every install.
12 minutes from Clackamas
Our shop in Oregon City is a short drive. Trucks dispatched from the closest crew.
Honest, flat-rate quotes
No upsell theater. Quotes locked before work starts. We tell you straight when a repair beats replacement.
Heat pump diagnostics
Heat pump repair in Clackamas means testing both modes.
Heat pumps are more complex than furnaces, and most repair shops don't train their techs deeply on the variable-speed inverter side. We do. Common faults: refrigerant leak, frozen outdoor coil from a stuck defrost cycle, failed reversing valve, or inverter board faults that throw manufacturer-specific codes.
We pull fault codes with manufacturer tools, verify refrigerant pressures by mode, test the defrost sequence, and check electrical at the contactor. Real diagnostics — not guess-and-replace.
Heating mode
Supply temperature, refrigerant pressures, and aux heat behavior.
Cooling mode
Reversing valve operation and charge behavior under cooling load.
Defrost cycle
Board, sensor, coil condition, and ice pattern.
Inverter and electrical
Fault codes, board communication, contactor, and line voltage.
Heat Pump Repair questions Clackamas homeowners ask
- Yes — we cover every ZIP in Clackamas (97015) and the surrounding Clackamas County area. 100% Satisfaction Guaranteed on every job.
- We're 12 minutes from our Oregon City shop, so trucks are rolling through Clackamas most days of the week. Same-day diagnosis on most heat pump repair calls.
- Older 100-amp electrical panels in 1960s–1980s Sunnyside-corridor homes that need upgrading before a heat pump install can land code-correct.
- Heat pumps build a small ice layer in heating mode. That's normal, and a defrost cycle melts it every 30–90 minutes. If the unit is fully encased in ice, the defrost cycle isn't running.
- Aux heat is normal during very cold weather (below ~30°F). But if it's running on a 45°F day, something is wrong: usually low refrigerant, a stuck reversing valve, or an undersized system.
- Yes. Trane, Mitsubishi, Carrier, Lennox, Goodman, Bryant, American Standard, and others. We have factory training on the major brands.
Written by Jason Morris, Co-Founder
Started in HVAC at A-Temp in 1994 · CCB#247087
Clackamas homeowners
Free in-home estimates across Clackamas.
Tell us what's going on. Same-day diagnosis on most heat pump repair calls in Clackamas.
More in Clackamas
Other services we offer in Clackamas.
- Furnace Installation in Clackamas
- Furnace Repair in Clackamas
- Furnace Maintenance in Clackamas
- Heat Pump Installation in Clackamas
- Ductless Mini-Split Installation in Clackamas
- AC Installation in Clackamas
Nearby cities